Kamry Tech Micro 1.0+ KeCig Atomiser
SKU:
A$5.00
A$5.00 - A$20.00
per item
The replacement atomisers for the Micro 1.0+ KeCig are an all-in-one unit - coil installed, so there's no need to do anything except fill and vape.
When they finally fail [still waiting for my first atomiser to give up and I'll let you know when it does] you simply replace the whole atomiser, fill and vape away again. It's just too easy.
It has a 1ml tank, running a 1.8 ohm coil @ 7W of power. Sounds silly and you'd think you'd need to refill it after every draw, but that's not the case at all . . . that tiny little 1ml tank lasted about 3 - 4 days without needing to be refilled during testing and it's still performing perfectly, 4 weeks later. Personally, I'm still trying to get my head around it.
Filling this little beast can be a little fiddly, cause it's a small filling space, but it's an easy process :
Atomisers are available as single units or in a 5 pack.
When they finally fail [still waiting for my first atomiser to give up and I'll let you know when it does] you simply replace the whole atomiser, fill and vape away again. It's just too easy.
It has a 1ml tank, running a 1.8 ohm coil @ 7W of power. Sounds silly and you'd think you'd need to refill it after every draw, but that's not the case at all . . . that tiny little 1ml tank lasted about 3 - 4 days without needing to be refilled during testing and it's still performing perfectly, 4 weeks later. Personally, I'm still trying to get my head around it.
Filling this little beast can be a little fiddly, cause it's a small filling space, but it's an easy process :
- Unscrew and remove the mouthpiece.
- Tilt the atomiser so the liquid will run down the inside wall [like you're pouring a beer] and fill between the coil wall and the outer wall [I use a 2ml syringe and a blunt drawing needle].
- Replace and screw on the mouthpiece.
- It's very important not to get any liquid down the centre hole of the coil, you'll just end up drinking it if you do, and we all know it tastes pretty icky.
- And don't over fill it : remember that you have to leave room for the mouthpiece to go back into place and screw down.
- And about replacement coils? . . . There aren't any : you replace the entire atomiser. Kamry Tech tell me that the atomisers have around a 2 week life span, but I'm still using the first atomiser from the kit and it's been over 4 weeks now. Mind you, I don't have it stuck to my face permanently [guess I'd call myself a moderate vaper these days] but I was spanking it pretty hard while testing it out.
Atomisers are available as single units or in a 5 pack.
